DISCONTINUED MODEL
| Key Features | 150W peak power | |
| Passive radiator powered subwoofer system | ||
| 3 points attenuator | ||
| Dual voice coil | ||
| RCA & speaker level input | ||
| Aluminimum Die-cast Back-frame | ||
| Variable cut-off frequency (50-120Hz) | ||
| Speaker Features | Speaker System | Active subwoofer system with Passive radiator |
| Speaker Type | Subwoofer | |
| Peak Input Power | 150W | |
| Speaker Size | 120 x 180mm | |
| Passive radiator system | Yes | |
| Dual Voice Coil System | Yes | |
| Wired remote included | Yes | |
| Cross-over Network | Built-in amplifier | |
| Amplifier Included | Built-in |
| Amplifier Features | Maximum power output | 150W |
| Low-pass Filter | Yes | |
| Phase inverter 0°(Normal) / 180°(Reverse) | Yes | |
| Power Indicator | Yes | |
| Line in | 1 RCA, 1 mini-jack | |
| Speaker level Input | Yes | |
| Chassis | Aluminum Die-cast Back-frame | |
| Die-Cast Aluminium Heat Sink | Yes | |
| Yes | ||
| DC cable Supplied | Yes | |
| Speaker/woofer Specifications | Peak Input Power | 150W |
| Woofer Cone material | Paper cone | |
| Speaker Basket | Steel | |
| Aluminum Die-cast back-frame | ||
| Speaker Surround | Rubber | |
| Sensitivity | 91dB/W/m | |
| Frequency Response | 35Hz ~ 120Hz | |
| Subwoofer Impedance | 2Ω x 2 | |
| Dimensions (W x H x D) | 369 x 94 x 224mm | |
| Gross Weight | 3400gr | |
| Amplifier-Specifications | Maximum power output (4Ω) | 150W x 1 |
| Low-pass Filter | 50~120Hz | |
| Signal to Noise Ratio | 85dB | |
| Frequency response (+0dB, -3dB) | 35Hz ~ 120Hz | |
| Operating voltage | 10.5V (16V ～ 14.4V allowable) | |
| Maximum current consumption | 8A |
| Accessories | Remote control | wired remote |
| Electro tap: 4 pieces | ||
| RCA cable | ||
| DC cord | 100 cm | |
| Screws (Parker-type) | Ø 5 x 16mm, 6 pieces | |
| Screws (M-type) | M4 x 6mm, 8 pieces | |
| Installation brackets | 1 pieces | |
| Adhesive tape pad | 1 piece(s) | |
| Bracket A | 2 pieces | |
| Bracket B | 2 pieces | |